Jump to content
Sign in to follow this  
fcbayern

Just wanted to share

Recommended Posts

So I came accross this pic in my phone of a build I did.. Twisted .28 then braided with .24.. Vapes nice .30ohms

twisted.thumb.jpg.63d4403a1f7cfa33a53d93

Share this post


Link to post
Share on other sites

Nice! I really need to start toying with twisted builds...

Share this post


Link to post
Share on other sites

Does that heat up properly?  Even with the gaps between the wraps?

 

I kinda want to try that out as well.

Share this post


Link to post
Share on other sites

I'm a big fan of twisted, not only does it look badass, it seems to perform a bit better, though that might just be confirmation bias.

Share this post


Link to post
Share on other sites

Yes it heats up nicely after a bit of tweaking. I like the twisted builds. It seems that something about the gaps adds to the flavor. Not sure really. The only drawback is, that its almost impossible to know what resistance you will end up with until you build it. Build calculators have a very hard time with these. So its trial and error at first. 

Share this post


Link to post
Share on other sites

Absolutely, I've a few builds that I had to scrap and start over because they ended up too low for my tastes. I think that's the thing people forget about, everyone got so used to building on non-regulated devices that they fail to realize that you can up your resistance quite a bit with a regulated and get the same performance. There has been more than a few times that I've thought "man, it would be nice to have a dripper that is wider" so I could have room to play around more. Even just having more room around the outside of the posts would help, so I could run a coil right around the outside...man that would be fun to build

Share this post


Link to post
Share on other sites

I can see the gaps adding more flavor/vapor.  It's more surface area in contact with the liquid.  It's the reason why I switched to almost strictly twisted builds.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...